Aalborg TIO Totalizer I/O Flow Monitor/Controller Manuel d'utilisateur télécharger pdf (Page 17)

5. LCD KEY-PAD OPERATION: DATA ENTRY AND

CONFIGURATION

5.1 Display Indications

Initially, after the power is first turned on, the Banner Screen is shown for 2 sec-

onds, then device firmware and EEPROM data base table revisions on the first line,

communication interface type on the second line, baud rate and RS-485 hexadec-

imal address value on third and fourth lines are shown for another 2 seconds.

Subsequently, the actual process information (PI) is displayed.

Figure 5.1: TIO Firmware and Communication Interface Info Screen

Based on device configuration (Device Function as flow meter or flow controller),

different parameters may be displayed in the Process Information (PI) screen by

pressing the UP or DN pushbuttons.

Process Information screens can be configured to be static or dynamic (see

Paragraph 5.3.11 “Display Menu”). Using Screen Mask settings user can enable

(unmask) or disable (mask) up to 4 different process information combinations

(see Figure 5.4). In the Static Mode the UP button pages through the PI screens

in the forward direction, the DN button pages through the PI screens in the reverse

direction. When the last PI screen is reached, the firmware “wraps around” and

scrolls to the initial PI screen once again.

In the Dynamic Display Mode, firmware initiates automatic screen sequencing with

user- adjustable screen Cycle Time (see Paragraph 5.3.11 “Display Menu”). When

the last PI screen is reached, the firmware “wraps around” and scrolls to the ini-

tial PI screen once again.

Fw: A002 Tbl: A001

Interface: RS-232

Baud Rate: 9600

RS485 address: 11

NOTE: Actual content of the LCD screen may vary depending on the

model and device configuration.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 97 98

Pas de commentaire

Aalborg TIO Totalizer I/O Flow Monitor/Controller Manuel d'utilisateur Page 17