Aalborg OSS-2 Optical Manuel d'utilisateur Page 1

OPERATING MANUALFOR OSS-2Optical SensorSwitchTechnical Data Sheet No. TDXXXXM Rev. BDate of Issue: March 9, 2006

7NO.INDICATION LIKELY REASON SOLUTION1No red LED lighton the top of the Tyne-Eye retro reflective sensors.Power supply off. Check connection of thepow

8APPENDIX 1COMPONENTS DIAGRAM2.012.203.001.002.22APPENDIX 2DIMENSIONAL DRAWINGS

9APPENDIX 3NOTE: Follow Return Procedures in Section 1.3.WARRANTYAalborg7 Optical Sensor Switch is warranted against parts and workmanshipfor a period

TABLE OF CONTENTS1. UNPACKING the Optical Sensor Switch...1.1 Inspect Package for External Damage...

Aalborg7 is a registered trademark of Aalborg Instruments & Controls.Aalborg7 reserves the right to make changes to information and specifications

11 UNPACKING THE Optical Sensor Switch1.1 Inspect Package for External DamageYour Optical Sensor Switch was carefully packed in a sturdy cardboard

23. INSTALLATION3.1 Electrical ConnectionsThe Optical Sensor Switch requires a +12VDC power supply with a minimum current rating of 250 mA. Operatin

3Important notes:In general, “D” Connector numbering patterns are standardized. There are, how-ever, some connectors with nonconforming patterns and t

44. SPECIFICATIONSMATERIALS OF CONSTRUCTION: END BLOCKS: Aluminum or 316 Stainless Steel.ELASTOMERS: Buna7 & Viton7 (Aluminum), Viton7 (316 SS)

56. OPERATING INSTRUCTIONSThe Optical Sensor Switch requires a +12VDC power supply with a minimum cur-rent rating of 250 mA. During initial power up

66.2 Sensor Alignments6.2.1 Position the sensor on the side panel of the flow tube until the upper small alignment screw becomes visible through the s